Display Messages - Yamaha CK88 Owner's Manual

Other information

Display messages

Messages
Auto power off disabled.
Bluetooth pairing...Press [EXIT] button to
cancel pairing.
Change [Pedal Live Set Inc/Dec] to [Off ].
Completed.
Connect a USB device.
Connecting to USB device...
Device number is off.
Device number mismatch.
File or folder already exists.
File or folder path is too long.
Illegal bulk data.
Illegal file name.
Illegal file.
Incompatible USB device.
Low Battery!
MIDI buffer full.
MIDI checksum error.
No read/write authority to the file.
Now receiving MIDI bulk data...
Now transmitting MIDI bulk data...
Please reboot to maintain internal
memory.
Press both [ENTER]+[MENU] buttons.
Speaker EQ is set to [Table].
Split Point does not exist.
Unsupported USB device.
USB connection terminated.
USB device is full.
USB device is write-protected.
USB device read/write error.
68
CK88 CK61 Owner's Manual
Description
This message appears when Auto Power Off is disabled.
The Bluetooth device and the CK are being paired. Press the [EXIT] button to cancel pairing.
Before changing the foot pedal assignment from the [SETTINGS] button, you need to set
the Live Set Inc/Dec parameter to off from the [MENU] button.
The specified operation (Load, Save, Format or another Job) has been completed.
There is no connected USB device.
Currently recognizing the USB flash drive connected to the USB [TO DEVICE] terminal.
Bulk data cannot be transmitted or received because the device number is off.
Bulk data cannot be received because the device numbers do not match.
A file or a folder having the same name as the one you are about to save already exists.
The file or folder cannot be accessed because the maximum length for the file name or the
pathname has been exceeded.
An error occurred while receiving a Bulk data or Bulk Request message.
The specified file name is invalid. Try entering a different name.
The specified file is unusable by the CK or cannot be loaded.
A USB device that cannot be used with the CK has been connected to the USB [TO DEVICE]
terminal.
The batteries are low. Replace the batteries.
Failed to process the MIDI data because too much data was received at one time.
An error occurred when receiving bulk data.
Indicates that you do not have the authority to read or write to the file.
Indicates the CK is receiving MIDI bulk data.
Indicates the CK is transmitting MIDI bulk data.
Reboot the CK to restore the internal memory.
Press the [ENTER] button and the [MENU] button simultaneously to disable the panel lock.
Speaker EQ has been set to Table.
Cannot change the Split Point because it has not been set.
This message appears when the connected USB flash drive is either unformatted, or
formatted in a way that the CK does not support. Please format the USB flash drive using
the CK.
Communication with the USB flash drive has been shut down due to overcurrent to the USB
flash drive. Disconnect the USB flash drive from the USB [TO DEVICE] terminal, and then
reboot the CK.
The USB flash drive is full and no more data can be saved. Use a new USB flash drive, or
make space by erasing unwanted data from the USB flash drive.
This message appears when you have attempted to write to a protected USB flash drive.
An error occurred while reading from or writing to a USB flash drive.