Usb Menu - Epson AcuLaser MX20DN series User Manual

USB Menu

Item
*1
USB I/F
*1 *2
USB Speed
*2 *3
Get IPAddress
*2 *3 *4 *5
IP Address
*2 *3
SM
*2 *3
GW
*2 *3
AppleTalk
*2 *3
Bonjour
*2 *3
USB Ext I/F Init
*1 *2
Buffer Size
*1
After this item is changed, the setting value takes effect after a warm boot or after the power is turned on again. While it is
reflected in the Status Sheet and EJL read-back, the actual change takes effect after a warm boot or after the power is
turned on again.
*2
Available only when USB I/F is set to On.
*3
Available only when a USB external device with D4 support is connected. The contents of the settings depend on the USB
external device settings.
*4
If the Get IPAddress setting is set to Auto, this setting cannot be changed.
*5
When the Get IPAddress setting is changed from Panel or PING to Auto, the panel setting values are saved. Then Auto is
changed back to Panel or PING, the saved setting values are displayed. The value is set to 192.168.192.168 if the settings
are not made from the panel.
USB I/F
Allows you to activate or deactivate the USB interface.
USB Speed
Allows you to select the operation mode of USB interface. Selecting HS is recommended. Select FS if HS
does not work on your computer system.
Buffer Size
Epson AcuLaser MX21/MX20 Series
Settings (default in bold)
On, Off
HS, FS
Panel, Auto, PING
0.0.0.1 to 255.255.255.255
0.0.0.0 to 255.255.255.255
0.0.0.0 to 255.255.255.255
On, Off
On, Off
-
Normal, Maximum, Minimum
User's Guide
Using the Control Panel 146