Inspection And Replacement Of Front Axle Oil; Lubrication Of Each Part - Mitsubishi GX50A Operator's Manual

MAINTENANCE

11. Inspection and Replacement of Front Axle Oil

WARNING For injury accident prevention
- Place the tractor on flat place and stop
the engine when inspecting and
replacing the front axle oil.
Inspection and Oil Supply
- If the oil comes out when removing the oil
check plug, it is appropriate. If insufficient,
supply oil to the oil filler port until the oil
comes out from the oil check hole.
Oil Check Plug Oil Check Plug
Oil Replacement
(1) Remove the drain oil plugs (3 places) and
drain the oil.
(2) Close the drain oil plug and supply a
specified amount of new gear oil from the oil
filler port (left).
(3) Remove the oil check plug on both sides and
close the plug after the oil comes out.
Drain Oil Plug Drain Oil Plug
NOTE
- Check the oil level before starting the
engine.
Oil Filler Port Oil Filler Port
MN00116_A
MN00117_A

12. Lubrication of Each Part

Brake Link (Left and Right)
- Lubricate the grease from the grease nipple
(Illustration indicates the brake link.)
Grease Nipple Grease Nipple
Rod End
- Lubricate an appropriate amount of grease
from the grease nipple (4 places).
Grease Nipple Grease Nipple
48
MN00118_A
Grease Nipple Grease Nipple
MN00119_A