Inspection And Replacement Of Transmission Oil - Mitsubishi GX50A Operator's Manual

MAINTENANCE
(5) Supply the coolant water to the <MAX>
(upper limit) of the reserve tank.
- When the coolant water is cooled, the
coolant water in the reserve tank is sucked
in, and the water level is reduced in the
reserve tank; thus, supply the coolant
water to the <MAX> (upper limit) of the
reserve tank.
- Use antifreeze "long-life coolant" containing
anticorrosive agent and lubricating agent
for the coolant water in order to prevent
corrosion inside the engine and radiator.
NOTE
- Use freshwater for the coolant water. Do not
use muddy water or briny water.
- The coolant water may be frozen in the
winter, and it may damage the engine or
radiator. Mix it with antifreeze "long-life
coolant" for use.
- Read the instruction manual of the cleaning
agent thoroughly when using cleaning agent
for the radiator.
- Replace the coolant water and clean inside
the radiator every two years.

9. Inspection and Replacement of Transmission Oil

WARNING
- Place the tractor on flat place and stop
the engine when inspecting and
replacing the transmission oil.
Inspection
- Remove the oil filler plug and make sure that
the oil level gauge indicates within the range
between the upper limit and lower limit
(specified amount).
- When the engine is running, the oil level
lowers. When checking the oil level, stop the
engine and wait for five minutes.
- Check the oil level before starting the engine.
Oil Supply
- Supply oil to the upper limit of the oil level
gauge when sufficient.
Oil Filler Plug
(with Oil Level Gauge)
[Upper Limit]
Specified
Amount
[Lower Limit]
Oil Replacement
(1) Remove the drain oil plug located in the
bottom part of the center of transmission
housing and drain the oil.
Drain Oil Plug
46
For injury prevention
Oil Filler Plug
(with Oil Level Gauge)
MN00113_A
MN00114_A