Creaning The Hydraulic Oil Filter; Checking The 4Wd Front Axle Oil Level And Its Replacement; Checking The Oil Level; Replacing The Oil Of Front Axle - Mitsubishi MT160 Instruction Book

t
CLEANING THE HYDRAULIC OIL FILTER
O-ring
Filter screen
Remove the filter at the time of draining the transmission
case oil, and clean the filter.
Loosen two bolts and remove the hydraulic oil filter
under the right part of the transmission case.
The removed oil filter should be thoroughly cleaned in the
detergent solution.
If the filter has been damaged, replace with a new one.
After installing the filter, make sure there is no oil leakage.
NOTE
1. If the transmission oil drained has to be reused,
wipe clean the surrounding surfaces of the drain
plug before draining, so that dust or dirt will
not get into oil.
2. Oil replacement should be carried out in every 200
hours under normal operating conditions. If oil
deteriorates excessively, replace it earl ier than
specified.
3. For installation of the oil filter make sure that the
pipe end of the filter is securely inserted into the
hole beside the suction pipe, and then install
the cover.
CHECKING THE 4-WD FRONT AXLE
OIL LEVEL AND ITS REPLACEMENT
CHECKING THE OIL LEVEL
Remove oil level plug to check that oil flows out. If not,
add gear oil. For changing oil, refer to "LUBRICATION
TABLE".
Specified quantity: MT180HD - 2.5 Q (3/5 gal, 1/3 guart)
REPLACING THE OIL OF FRONT AXLE
o
Drain plug
Oil level plug
-35 -