Table of Contents
Advertisement
10. Inspection and Replacement of Transmission Oil
WARNING
For injury prevention
- Place the tractor on flat place and stop
the engine when inspecting and
replacing the transmission oil.
Inspection
- Remove the oil filler plug and make sure that
the oil level gauge indicates within the range
between the upper limit and lower limit
(specified amount).
- When the engine is running, the oil level
lowers. When checking the oil level, stop the
engine and wait for five minutes.
- Check the oil level before starting the
engine.
Oil Supply
- Supply oil to the upper limit of the oil level
gauge when sufficient.
Oil Filler Plug
(with Oil Level Gauge)
[Upper Limit]
Specified
Amount
[Lower Limit]
Oil Replacement
(1) Remove the drain plug located at the bottom
part of the center of transmission housing
and drain the oil.
Oil Filler Plug
(with Oil Level Gauge)
1944_0064
Drain Oil Plug
1944_0065
(2) Close the drain plug and supply new gear oil
to the upper limit of the oil level gauge.
NOTE
- Check the oil level before starting the
engine.
MAINTENANCE
39
Advertisement
Table of Contents
