Operation - Husky HOTC5213B1OS Use And Care Manual

Operation

1
Locking and unlocking the unit
IMPORTANT : The drawers must be fully closed before
locking / unlocking the unit.
□ Insert the key (K) and turn it counterclockwise, one
quarter turn to lock.
□ Remove the key (K).
□ Insert the key (K) and turn it clockwise, one quarter turn
to unlock.
□ Remove the key (K).
NOTE: Key codes for chest and cabinet will be different.
K
3
Installing the drawers
□ Pull the slides and slide carrier out until fully extended.
□ Hold the slide on the cabinet while aligning it with
the slide on the drawer.
□
Slightly insert one side and repeat for the other side.
□ Slowly push the drawer until it is fully closed to
engage the slide.
□ Open the drawer and close it to verify proper
operation.
2
Removing the drawers
□ Fully extend and empty the drawer.
□ Depending on the slide, either lift or lower the
release lever on both sides so the slides can ride over
the stops. Pull out to remove.
4
Preparing the electrical hole
WARNING: Be careful when putting your power cord
through the hole since there may be sharp edges around
the punched hole.
□ A perforated hole is located in the back of the chest to allow
for the use of a power cord while the chest top lid is closed.
□ The perforation can be removed by pushing along the edge and
twisting the disk until it pops free. Take care not to damage the
cabinet around the perforation when punching the hole through.
□ Use a metal file to smooth out any sharp edges around the hole
to help prevent injury.
8