Setting Time And Date [Time & Date] - Olympus LS-10 Instructions Manual

Notes
• If you press any button in HOLD mode, the
clock display flashes for 2 seconds, but it will
not operate the recorder.
• If HOLD is applied during playback (record-
ing), operation is disabled with the playback
(recording) state unchanged (When playback
1
has ended and the recording has ended due
to the remaining memory being used up, it will
stop).
Setting Time and Date [Time & Date]
If you set the time and date beforehand, the information when the file is recorded is automatically stored
for each file. Setting the time and date beforehand enables easier file management.
When you use the recorder for the first
time after purchasing it, or when the
batteries have been inserted without the
device having been used in a long time,
the [Set Time & Date] will appear. When
the [hour] is flashing, conduct the setup
from Step 1.
12
HOLD/Setting Time and Date [Time & Date]
• The recorder can be effectively operated via
its switch and dial, as well as the connected
exclusive remote control set RS30W (optional),
even when it is in HOLD mode.
1
Press the 9 or 0 button to select
the item to set.
2
Press the 2 or 3 button to set.
Follow the same steps by pressing the 9
•
or 0 button to select the next item, and
press the 2 or 3 button to set.
2 3 button
9 0 button
`/OK button
LIST button
Select the item from
[hour], [minute],
[year] [month] and
[day] with a flashing
point