Table of Contents
Advertisement
4. Insert a piece of wood into the cutting
deck to prevent the blade from spinning
during loosening of the blade nut. Loosen
the blade nut.
5. Remove the blade nut, spacer, and
washer. Remove and properly dispose of
the old blade.
6. Install the new blade, washer, spacer,
and nut.
7. Insert a piece of wood into the cutting
deck to prevent the blade from spinning
during tightening of the blade nut. Hand-
tighten the nut until the blade is secured
and does not shake.Then use a spanner
to further tighten the nut by 1/2 turn (35-
40 Nm torque).
WARNING: Ensure to remove the blade
change lock and place it back into the
compartment before reinstalling the battery
pack to begin mowing again.
4
1
5
6
7
1
2
15 mm
2
Maintenance
15
Advertisement
Table of Contents
