THANK YOU FOR BUYING A RYOBI PRODUCT. INSTRUCTIONS FOR SAFE HANDLING THANK YOU FOR BUYING A RYOBI PRODUCT. THANK YOU FOR BUYING A RYOBI PRODUCT. f) Dress properly. Do not wear loose clothing or jewellery. f) Dress properly. Do not wear loose clothing or jewellery.
MAINTENANCE & STORAGE OF TRIMMER: 8. Thoroughly inspect the area where the Trimmer is to be used and remove all foreign objects. WARNING! WARNING! 1. Disconnect the spark plug before performing Your equipment can throw small objects at high speed maintenance.
SPECIFICATIONS provided metal clips as shown. Secure the pivot cable with provided plastic cable tie. Engine type ..........43cc, 2-stroke Engine speed ..........7000~8000min Cutting Head Assembly (Fig. 3, 4) Cutting width ............420mm 1. Install the cutting head assembly (1) into the clutch Cutting height ............
Page 10
4. When trimming next to wire type fencing, avoid 1. Throttle (Fig. 15) cutting-line contact with the fence. Contact will result in The throttle lever (12) is located on the top crossbar on rapid line wear. Likewise, contact with concrete and brick the upper handle.
Page 11
Starting A Flooded Engine: 5. Follow instructions on 2-cycle oil container for mixing fuel. Mix gasoline and 2-cycle oil at a ratio of 50:1. A 1. Place the Trimmer on a flat surface. mixture with a 50:1 ratio is obtained by mixing 1 gallon 2.
Techniques / Applications: Engine Air Intake Screen: Trimming Tip NOTICE It is critical that the engine air intake screen be cleaned of To extend the life of the trimmer line, keep the trimmer line moist. If not kept moist, the nylon line will become dry and debris to maintain acceptable engine temperatures.
Page 13
4. When preparing the Trimmer for storage or when Trimmer will not be used for 30 days or more: a. Inspect and clean the Trimmer thoroughly. b. Lightly oil all external metal surfaces. c. Remove the spark plug, place a few drops of 2-cycle engine oil into the cylinder.
TROUBLESHOOTING PROBLEM POSSIBLE CAUSE(S) SOLUTION(S) Engine will not start. 1. Ignition Switch in the “OFF” 1. Move ignition switch to the ON position. position. 2. See Starting a Flooded Engine in OPERATION section. 2. Engine flooded. 3. Fuel Tank empty. 3.