Table of Contents
Advertisement
Select FLASH MODE in the menu, then
select the flash mode.
Press the shutter button halfway.
The icon of the
selected flash mode
Press the shutter
button all the way
down (fully) to take
the picture.
● When using a situation-related shooting mode (
used.
● The flash cannot be used during movie recording.
● When there is a likelihood that camera movement will occur in the flash off
mode, the
(camera movement warning) mark blinks. Use the flash.
Red-eye reduction flash
● The red-eye reduction flash cannot be used during sequential shooting.
~
P. 61
● After the pre-flash, it takes approximately 1 second before the shutter is
released. Hold the camera firmly after the pre-flash to prevent camera
movement.
● Effectiveness may be limited if the subject is not looking directly at the pre-
flashes, or if the shooting range is too far. Individual physical characteristics may
also limit effectiveness.
Fill-in flash
(
● Fill-in flash may not have the desired effect under excessively bright light.
Flash off
(
)
● Since a slow shutter speed is automatically selected in low-light situations when
in the flash off mode, the use of a tripod is recommended to prevent your
pictures from being blurred by camera movement.
~
P. 55
Half press
P P
SH
3M
Full press
Notes on flash
(
)
)
Selecting functions from the shooting menu
Shutter button
MENU/OK button
The
(flash stand-by) mark lights
when the flash is ready to fire. If the
mark is blinking, the flash is charging.
Wait until charging is complete.
Flash working range
W (max.) : Approx. 0.3 m - 3.6 m
(1.0 ft - 11.8 ft)
T (max.) : Approx. 0.3 m - 2.0 m
(1.0 ft - 6.6 ft)
~
P. 45), the flash may not be
~
P. 36
Control dial
BACK/NEXT
button
4
59
Advertisement
Table of Contents
