Kawai CA401 Owner's Manual page 43

5. Connecting the cables
Pass the pedal connection cable coming out of
the pedal board (E) through the aperture of the
back board (D) to the back of the instrument, and
connect it to the PEDAL terminal on the bottom of
the main body (A).
Connect the power cable into the [AC INLET]
terminal.
Use the binders on the side boards (B) to x the
cables in place.
CAUTION
When inserting the plug at the end of the
pedal cable into the jack on the bottom of
the main body of the digital piano, be sure
to align the pins with the position of the
hole in the jack, and then insert the plug
straight into the jack as far as it will go. If
the plug is forcibly inserted in the
improper alignment, the pins may bend or
break.
6. Attaching the front under board (F)
Attach the front under board (F) to the metal
brackets located underneath the main body using
the two at headed screws
7. Attaching the headphone hook
Attach the headphone hook to the underside of
the main body using the two installation screws
provided as shown in the illustration below.
8. Adjusting the pedal support bolt
Be sure to turn the pedal support bolt on the back
of the pedal base (E) anti-clockwise to extend the
bolt until it makes contact with the oor and
supports the pedals rmly. Depending on the
material and condition of the oor, r r there may a
noise caused by friction with the oor when the
pedal is depressed. If this happens, place felt or
carpet between the pedal support bolt and the
oor. r r
CAUTION
If the instrument is used with the pedal
support bolt oating o the oor or
pressed strongly against the oor, r r the
pedal board may be damaged. When
moving the instrument, lift f f the instrument
o the oor and do not drag it.
Appendix
.
43