Kawai CA401 Owner's Manual page 41

1. Attaching the side panels (B and C)
to the pedal board (E)
Unfasten and extend the pedal connection cable
attached to the bottom of the pedal board (E).
Attach the side panels (B and C) to the pedal
board (E) using the temporary mounting screws
located on either end of the pedal board.
Ensure that the side panels (B and C) make close
contact with the pedal board (E) so that there are
no gaps between the parts, and tighten the
temporary mounting screws.
Insert the four short silver tapping screws
into the remaining screw holes as shown, and
securely fasten the pedal board to the left f f and
right side panels.
2. Attaching the back board (D)
Stand the assembled structure of the pedal
board (E) and side panels (B and C) upright
(vertically) on the oor as shown in the illustration
below.
At this time, ensure that there are no parts or
sheet music on the oor, r r and that the adjustor bolt
is attached to the pedal board.
Loosely attach the back board (D) to the left f f and
right side panels (B and C) using the four long
black tapping screws
Secure the back board (D) to the pedal board (E)
using the four short black tapping screws
Tighten the loosely fastened long black tapping
screws so that the left f f and right side panels (B
and C) and the back board (D) are aligned and in
complete contact with no spaces.
CHECK
Depending on the colour of the
instrument, black screws may be replaced
with silver screws.
.
.
Appendix
41