3.3.4 SW9, DSP PCIESS Enable and User Defined Switch Configuration
SW9 is a 2‐position DIP switch. The first position is used for enabling the PCI Express
Subsystem within the DSP. The second position is undefined by hardware and available for
application software use. A diagram of the SW9 switch (with factory default settings) is
shown below:
The following table describes the positions and corresponding functions on SW9.
Table 3.17: SW9, DSP PCI Express Enable and User Switch
SW9
SW9[1]
SW9[2]
ON (0x0b)
Logic Low
SW9
OFF (0x1b)
Logic High
Figure 3.7 : SW9 default settings
Description
Default Value
PCIESSEN
0b (ON)
User Switch
0b (ON)
ON
1
2
Function
PCIe module enable.
0 = PCIe module disabled
1 = PCIe module enabled
Application software
defined
44