Set Brush Angle; Transport Unit; Adjust Engine Air Cleaner - Ariens Power Brush 36 Operator's Manual

SET BRUSH ANGLE

See Figure 14.
1. Squeeze brush lock trigger to unlock
brush position.
2. Move handlebars left or right until brush is
in desired position.
3. Release trigger to lock brush position.
Figure 14

TRANSPORT UNIT

1. Stop engine and close fuel valve.
2. Secure unit chassis to transport vehicle.
NOTICE: NEVER secure from rods or
linkages that could be damaged.
For Best Sweeping Results
• Run in an overlapping series of paths.
• Start in the middle of large areas and
sweep debris to each side.
• ALWAYS direct discharge with wind
direction.
• Snow is most easily removed as soon as
snow falls.
For Best De-Thatching Results
IMPORTANT: Front caster kit is required for
de-thatching. See Accessories on page 25.
• De-thatch in spring to clear winter
undergrowth.
• Adjust brush height so it just touches the
grass.
• Set brush angle full left or right so thatch
gets cleared only once.
• De-thatch dry grass.
• Use a slow speed to clear thatch to avoid
damage to lawn.

ADJUST ENGINE AIR CLEANER

See Figure 15.
1. Pull down latches and move tabs away
from base to release air cleaner cover.
2. Rotate cover to the cold-weather/winter
position or summer position. See
Figure 16.
NOTICE: DO NOT run engine with air filter
cover in the winter/cold-weather position
while operating in normal temperatures.
EN - 13
Figure 15