Table of Contents
Advertisement
Network Settings (Wireless)
― This function may not be supported depending on the model.
Connecting to a Wireless Network
Wireless IP sharer
(router having DHCP server)
The LAN Port on the Wall
LAN Cable
Samsung recommends using IEEE 802.11n. When you play video over a network connection, the video
may not play smoothly.
― Select a channel for the wireless IP sharer that is not currently being used. If the channel set for the wireless
IP sharer is currently being used by another device nearby, this will result in interference and communication
failure.
― Your product supports only the following wireless network security protocols.
–
Authentication Modes: WEP, WPAPSK, WPA2PSK
–
Encryption Types: WEP, TKIP, AES
In compliance with the Wi-Fi certification specifications, Samsung products do not support WEP or TKIP
security encryption in networks running in the High-throughput(Greenfield) 802.11n mode.
― If your wireless router supports WPS (Wi-Fi Protected Setup), you can connect to the network via PBC (Push
Button Configuration) or PIN (Personal Identification Number). WPS will automatically configure the SSID and
WPA key in either mode.
― Connection Methods: You can setup the wireless network connection in three ways.
Automatic Network Setup, Manual Network Setup,
Use WPS
Automatic Network Setup (Wireless)
Most wireless networks have an optional security system that requires devices that access the network
to transmit an encrypted security code called an Access or Security key. The Security key is based on
a Pass Phrase, typically a word or a series of letters and numbers of a specified length you were asked
to enter when you set up security for your wireless network. If you use this method of setting up the
network connection, and have a Security key for your wireless network, you will have to enter the Pass
Phrase during the automatic or manual setup process.
How to set up automatically
1
Set
Network Type
to
Wireless
from the
Open Network Settings
2
The
Network
function searches for available wireless networks. When done, it displays a list of the
available networks.
In the list of networks, press the ▲ or ▼ button to select a network, and then press the E button.
― If the desired wireless router does not appear, select
― If the router cannot be found after retrying, select the
3
If the
Enter the password for (AP Name).
that does not have security, go to step 6.
4
If the router has security, enter the
Enter the password for (AP Name).
5
When done, use the right arrow button to move the cursor to Done, and then press E. The network
connection screen appears and the verification process starts.
― A connection with the router is established, but the Internet cannot be accessed. In this case, contact your
Internet service provider.
6
When the connection has been verified, the
have any problems using online services, please contact your Internet service
appears.
page.
Refresh
to search again.
Add
Network.
screen appears, go to step 4. If you select a wireless router
(Security key or PIN).
"Success! Your device is connected to the Internet. If you
provider." message
73
Advertisement
Table of Contents
