Table of Contents
Advertisement
E.16.1 Rinse aid dispenser
The left or right side panels of the dishwasher have a "T"
injector [⌀=6 mm] for connecting the rinse aid dispenser.
To connect the dispenser, carefully carry out the following
instructions:
• unscrewing the "U" fitting from the "T" injector;
• connect the rinse aid pipe, coming from the external
dispenser, on the "U" fitting;
• screw the "U" fitting tightly to the "T" injector paying careful
attention to any potential plumbing leaks.
1
T
U
2
E.16.2 Liquid detergent dispenser
The left or right side panels of the dishwasher have a "P"
injector [⌀=6 mm] for connecting the detergent dispenser.
To connect the dispenser, carefully carry out the following
instructions:
• unscrewing the "R" fitting from the "P" injector;
• connect the detergent pipe, coming from the external
dispenser, on the "R" fitting;
• screw the "R" fitting tightly to the "P" injector paying careful
attention to any potential plumbing leaks.
1
P
R
2
E.16.3 Solid detergent dispenser
The left and right side panels of the dishwasher have a hose
union "P" for connecting the solid/powder detergent dispenser.
To connect the dispenser, carefully carry out the following
instructions:
• fit the solid detergent pipe, coming from the external
dispenser, on hose union "P";
• secure the pipe to the hose union with a clamp "B".
3
3
P
E.16.4 Conductivity probe
Remove the front panel. In the lower part of the tank there is an
additional closed hole (⌀ = 22 mm) to be used for the
installation of the conductivity probe.
With a 24 mm wrench remove the plug and install the
conductivity probe.
E.17 Dispensers electrical connection
CAUTION
Do not make direct connections on the
printed circuits.
NOTE!
The connection cables must comply with the stand-
ards: CEI EN 60332, CEI EN 50265, CEI 20 - 35,
CEI 20 - 20.
Open the door electric box and pass the cables for electrical
connection through the connection cables "1" or "2".
B
23
Advertisement
Table of Contents
