How To Use; Getting Started; Bake Function - Black & Decker CTO6335SC Manual

HOW TO USE

This appliance is intended for household use only.

GETTING STARTED

• Remove all packing material, any stickers, and the plastic band around the power plug; peel off
clear protective film from control panel.
• Please go to www.prodprotect.com/blackanddecker to register your warranty.
• Wash all removable parts as instructed in Care and Cleaning section of this manual.
• Select a location where this unit is to be used allowing enough space for back of the unit and the
wall to allow heat to flow without damage to cabinets and walls.
• Insert crumb tray below lower heating elements.
• Remove tie from cord and unwind.
• Plug unit into electrical outlet. The digital display shows 0:00.
Important: When using the oven for the first time, you may notice smoke or a slight odor during
the first few minutes. This is normal.
SLIDE RACK POSITIONS
There are four positions for the slide rack. It can be inserted in either the upper or lower slot. It can
also be inverted for two additional positions.
Position 1
Use upper slots along oven walls. Insert rack using a rack-up position.
Position 2
Use lower slots along oven walls. Insert rack using a rack-up position.
Position 3
Use upper slots along oven walls. Insert rack using a rack-down position.
Position 4
Use lower slots along oven walls. Insert rack using a rack-down position.

BAKE FUNCTION

Selecting Cooking Temperature and Time
Note: You have 10 seconds for selecting the temperature and time. If you exceed this time, the
display will change back to the default (000) temperature and time; simply repeat steps 1-5 below to
begin again. To change temperature scales, press ▲ and ▼ buttons simultaneously.
1. Press BAKE
temperature flashes on the digital display.
2. To adjust the temperature, immediately press ▲ or ▼ button until you reach desired
temperature.
Note: Cooking temperature can be adjusted from 200˚F to 450˚F.
• Tap button and release to change in increments of 5 degrees.
• Press and hold button to change rapidly in increments of 25 degrees.
3. To set the cooking time, press the TIMER
cooking time of :30 (30 minutes) flashes on the display; otherwise it will display the last selected
time.
4. Immediately press ▲ or ▼ buttons to select desired time up to a maximum of
2 hours.
• Tap button and release to change in one-minute increments.
• Press and hold button, to change rapidly in 10 minute increments.
5. Once you have set desired temperature and time, press START/STOP button.
• Digital display flashes LO and PREHEAT until the unit reaches 150˚F then it flashes temperature
until the set temperature is reached.
6. Open oven door. Insert food to be cooked or heated in bake pan or pizza pan into the oven.
7. Close oven door.
Important: You cannot change the temperature or time during the preheat cycle. Once unit reaches
selected temperature, temperature and time can be changed. For your convenience, the unit
always remembers the last selected setting, unless unplugged.
Note: You can stop the cooking at any time by pressing the START/STOP button.
8. To open the oven door, use an oven mitt to grip handle and gently pull forward to bring door down
until it rests on the counter.
6
CTO6335SC_29308_EF_IB_D.indd 6 CTO6335SC_29308_EF_IB_D.indd 6
button. The unit beeps, Power indicator light blinks and 350°F default
button. If you just plugged in the unit, the default
7/13/22 2:22 PM 7/13/22 2:22 PM