Nfc (Near Field Communication) Operation; Connecting An Nfc Device With One Already Connected - JVC UX-D100 Instruction Manual

NFC (Near Field Communication) Operation

Pair your NFC-enabled mobile device directly with this unit with a single tap. Your unit will
automatically switch on if in standby or switch modes to Bluetooth mode and pair with
your mobile device.
1. Activate NFC on your mobile device.
2. Tap the mobile device on the
up. Your unit will switch to Bluetooth® mode automatically. If the unit is in standby
mode it will also switch on and go into Bluetooth mode.
3. Operate your mobile device directly for playback features.
4. To disconnect you can switch your unit into standby, switch modes or turn Bluetooth
off on your mobile device.
• The NFC function only works with mobile devices that support NFC technology.
• You may need to remove your mobile device case to connect using NFC.
• Your unit has an auto reconnect feature which will automatically reconnect your Bluetooth device with
your unit (this feature may not be available on all Bluetooth devices). So as long as Bluetooth is left
switched on, on your mobile device it will automatically reconnect to your unit when you come back
home, when the unit is switch on and in Bluetooth mode.

Connecting an NFC Device with one Already Connected

You can only connect one NFC device at a time. If an NFC device is already connected, the
connected device must be disconnected before you can connect another NFC device. This
is to prevent someone from changing the music you are playing without your permission.
1. In the Bluetooth settings of the connected device select disconnect. The Bluetooth
device will now disconnect.
2. While the unit is in Bluetooth mode touch the other NFC device against the NFC sensor,
the device will now connect.
If its the first time the NFC device has been used you with your unit you will be asked if you want to
connect. Confirm you want to connect.
UX-D100_IB.indd 25
icon on the unit. The device vibrates or a message pops
Distance between
device sensor and
sensor area on the unit
should be less than
10mm
25
21/04/2015 10:29