Fm Radio Operation; Tuning In A Station; Presetting Stations; Recalling A Preset Station - JVC UX-D100 Instruction Manual

FM Radio Operation

• Make sure the aerial is correctly connected and fully extended, away from
any electrical devices that could cause interference.
• If reception is still poor, try to adjust the FM/DAB aerial location.
Press the SOURCE button on the unit or press FM/DAB button on the remote control to
select the TUNER (FM) source. The word "TUNER" will be showed on the display.

Tuning in a Station

Auto Tuning
Press and hold
The search may not stop at a station with a very weak signal.
Manual Tuning
Press / repeatedly to change the frequency until you find the station you want.
With FM radio it may be necessary to fine tune each station by pressing
adjust the frequency by 0.05MHz. If reception is still poor adjust the position of the aerial or try moving
the unit to another location.

Presetting Stations

You can store up to 20 stations to the memory, allowing access to your favourite stations
quickly and easily.
Automatically
Press and hold PROGRAM for a few seconds. The word 'SCANNING' will briefly appear on
the display. The unit will automatically search and store the first 20 radio stations it finds.
Manually
1. To store a preset, you must first be listening to the station that you want to save.
2. Press PROGRAM to activate program mode. The preset number will blink e.g. "01".
3. Press ALBUM/PRESET / to select the desired station preset number.
4. Press PROGRAM again to store the station, the program number will now stop blinking,
your program is now saved.

Recalling a Preset Station

You can recall any saved station by pressing ALBUM/PRESET / .
UX-D100_IB.indd 19
/ for a few seconds, the unit will tune to the next available radio station.
/ repeatedly. Each press will
19
21/04/2015 10:29