Mitsubishi GX36A Operator's Manual page 18

FUNCTIONS OF EACH PART
Starter Key Switch
WARNING For injury accident prevention
- Keep the key removed when not using
the tractor.
< > {OFF}
The starter key switch can be removed in this
position. Engine and all lamps except the turn
signal and flasher lamps are turned off.
< > {ON}
First position turn to forward from OFF.
The charge indicator and oil pressure indicator
will illuminate.
The fuel gauge and temperature gauge will
show correct values.
< > {HEAT}
In this position (Engine not running) energizes
the glow plugs.
NOTE
Time to warm the engine is less than 8
seconds.
< > {START}
Turn the key fully forward against the force of
the spring in the switch.
The starter motor will turn the engine. Release
the key immediatery when the engine starts.
NOTE
- The engine does not start if the clutch pedal
is stepped completely.
6
Manual
HEAT
OFF ON
Tachometer
The tachometer shows the engine speed in
revolutions per minute (RPM).
Hourmeter
The hour meter displays the adjusting time at
the engine driving time.
Fuel Gauge
The meter shows how much fuel is in the tank.
NOTE
- The pointer can be in lowest position when
the starter key switch is in the OFF
position. To get a fuel level indication, turn
the starter key switch to the ON position.
Engine Coolant Temperature Gauge
The gauge indicates the coolant temperature
when the starter key switch is in ON position.If
the engine overheats, the pointer moves to the
up side into H position area. In this case,
discontinue work and run the engine at
1500rpm without load until pointer moves
down. If the pointer stays high temperature
area, stop the engine. After the engine cools
down, check for the cause.
Manual
Manual
Automatic
Return
START
Starter Key Switch
1944_0009