Installation Of Usb Function - Compaq P1210 User Manual

Installation of USB Function

The following procedure permits your computer to recog-
nize or "enumerate"(A USB term) the USB HUB.
1. Power on the display monitor and then the
computer.
2. Start "Enumeration" from the Windows
N O T E
• During the enumeration of the USB Hub, connect the
keyboard and mouse, to the computer and not to the
downstream ports on the display monitor. After the
enumeration, the keyboard and mouse can be used by
connecting to the downstream ports, if they are USB-
compliant.
• Do not unplug the USB cable during the enumerations.
(1) Connect the computer and the display monitor with an
USB cable. The screen below will appear.
(2) Click "Next".
(3) Click "Finish" on the second screen to complete the
enumeration of the USB HUB.
You can confirm that the USB HUB is successfully enumer-
ated with the following method.
• Open "Device Manager" tab in "System" property
under "Control Panel". Confirm that "Generic USB
HUB" is listed in "Universal Serial Bus Controller". If
you can't confirm it, re-enumerate the USB HUB
again by following (a) or (b).
(a) Disconnect and connect the USB cable to the up-
stream port of the display monitor.
(b) Cycle power of the display monitor off then on.
N O T E
® Desktop.
If the mark
enumeration was unsuccessful. Select "Generic USB
HUB" marked with
"Refresh". After that, the enumeration is automatically
started.
N O T E
The enumeration of USB HUB may be necessary for
each USB port on the computer.
- 3 -
appears with "Generic USB HUB", then
mark and click "Remove" and