Locking And Unlocking The Safe; Locking The Safe; Unlocking The Safe With Your Passcode - Honeywell 2911 User Manual

LOCKING AND UNLOCKING THE SAFE

LOCKING THE SAFE

With the handle in the unlocked position, tightly close the safe door. (Figure 1)
1.
Push the handle down into the locked (vertical) position to activate the door bolt. (Figure 2)
2.
IMPORTANT: This safe is equipped with an air-tight seal which allows it to meet the fire and
water protection claims outlined at the beginning of this user guide. Due to the tight fit of the
seal and door, you may need to push down the handle with some force to lock it into place. You
will feel the handle click into place when locked.
Check that the safe is locked by attempting to move the handle. It should remain in the locked
3.
(vertical) position.
Figure 1

UNLOCKING THE SAFE WITH YOUR PASSCODE

Enter your passcode followed by the # key. (Figure 1)
1.
• If the passcode is entered correctly, the indicator bar will turn green. (Figure 2)
• If the passcode is entered incorrectly, the indicator bar will turn red. (Figure 3)
After entering the correct passcode, lift the handle to the right to retract the bolt and
2.
unlock the door. (Figure 4)
Figure 1
Time Out Feature
After entering the passcode, you will have 5 seconds to turn the handle and unlock the door
before the safe will lock again and you will need to reenter the passcode.
Lockout Feature
For added security, the safe is programmed to lock out users if an incorrect passcode is entered
three times in a row. The safe will remain in lockout mode for 15 minutes. During this time, the
safe can be opened using the Override Access Keys.
Figure 2
Green = Passcode Set Successfully
Figure 2
5
Red = Passcodes Don't Match
Figure 3 Figure 4