Getting Started; Deleting Interfaces With The Bcc - Bay Networks BayRS Release Note

Release Notes for BayRS Version 13.10
• OSPF
• PPP (certain line parameters only; no multiline or multilink supported)
• Proprietary Standard Point-to-Point
• RIP
• Router Discovery (RDISC)

Getting Started

Caution: BCC configuration and source commands make immediate
changes to the active device configuration. Read about the
in Using the Bay Command Console (BCC).
Before using the BCC, save your configuration files by copying them onto the
same flash memory card using new file names.
To start the BCC, enter
To display the online instructions for new BCC users, enter
the
bcc>
interface, just enter the
For more information about how to use the BCC interface, see Using the Bay
Command Console (BCC).
For instructions on using the BCC to add and change configurable services, see
the documentation for that service.

Deleting Interfaces with the BCC

Before using the BCC to delete an interface, make sure that you did not use Site
Manager to configure the interface with a protocol that the BCC does not
recognize. If you did, use Site Manager to delete the interface.
8
at the Technician Interface prompt.
bcc
prompt. To display a full summary of the Help features of the BCC
command at any BCC prompt.
help
command
source
help learning-bcc
301151-C Rev 00
at