Configuring Nokia 3510I Midp Sdk With Ides; Configuring Jbuilder To Recognize Nokia 3510I Midp Sdk - Nokia 3510i User Manual

Configuring Nokia 3510i MIDP SDK With IDEs

This chapter describes how to configure the SDK so you can use it with your IDE.
You'll need to configure your IDE to recognize the SDK as a supported device before you can
launch the SDK from within the IDE interface. The method used for launching the SDK varies on
the IDE, and it is beyond the scope of this document to describe integration with all IDEs.

Configuring JBuilder to Recognize Nokia 3510i MIDP SDK

Before you begin to configure JBuilder to recognize the SDK, make sure you have installed
JBuilder, MobileSet, and the SDK as described in Nokia 3510i MIDP SDK Installation Guide.
To configure JBuilder to recognize the SDK:
1 In JBuilder, choose Tools>Configure JDKs. A dialog such as the following is displayed:
Nokia 3510i MIDP SDK User's Guide
11