Advertisement
_____________________________________________________________________
Scream Tube
This will is a nice echo screaming synth noise
On synth effect set the following parameters:
Synth Common
[off,99,-,off,0]
Synth LFO
[0,0,tri,off]
Virtual VCO
[on,saw,0,0,0,4,0,13,on,pls,42,36,16,0,0,osc1,osc1]
Virtual VCF
[80,0,0,0,0,lpf,-12,100,24,53,0,36,0,0,0,0,off,23]
Virtual VCA
[0,38,0,44,100,20,0,0,0]
Simple Dly
[alt,-,23,dotted eighth note,69,100]
Chors/Flang
[chors,inv,69,71,22,96,off]
StepMod
[1 step, 2,{0,127}, quarter note, song, 80%]
Try holding down the step mod for a few seconds, gets kinda fun when you tweak it too...
___________________________________________________________________ __
SP-808 Stomper
Use "20:Virtual analogue synthesizer." in SP-808 effects.
1. Open "step sequencer"
set the parameter.
repeat,4,1/16,song,80
"E2 rst rst rst"
2. Open "FX parameter"
set the parameter. COM:off,100,-,off,0
LFO:34,-,saw,1/16
VCO:free(useless)
VCF:0,0,100,0,0,LPF
,-24,21,100,100,0,35,0,54,8,0,ON,100
VCA:0,84,0,100,100,54,0,0,100
3. Set effect control(CTL)
nob:parameter :range
C1 :VCA Env.dpth:58-200
C2 :VCF atack :0-100
C3 :VCF decay :24-44
C4 :VCF LFO.dpth:0-22
C5 :VCF cut off :0-100
C6 :VCF Env.dpth:0-100
StM1:COM on NOTE
StM2:-----------
4. Set effect's location "send/return"
and make step sequencer "on"
5. Touch control nobs.
If you make good kick sounds, sample it immediately!
Advertisement
