3-2 NT5K19 Analog Tie Trunk Card
Common features
Trunk circuit features
553-3001-173 UK Trunk cards description
United Kingdom
United Kingdom
United Kingdom
United Kingdom
United Kingdom
United Kingdom
Note:
Type I signalling uses two signalling wires plus ground.
The NT5K19 Analog Tie trunk card:
•
converts transmission signals from analog-to-digital and from digital-
to-analog
•
enables and disables individual ports or the entire card under software
control
•
provides outpulsing on the card. Make break ratios are defined in
software and down loaded during power up and by software
commands.
•
provides indication of card status from self-test diagnostics on
faceplate Light Emitting Diode (LED)
•
allows trunk type to be configured on a per port basis in software
•
provides termination against 600 ohms for 4-wire E&M trunk circuits
•
provides termination and transhybrid balance matching against the UK
three component complex impedance network for 2-wire E&M trunk
circuits
•
provides termination against 600 ohms for AC15 trunk circuits
•
provides for loss pads appropriate to low loss lines or point-to-point
lines on 4-wire E&M and AC15 connections
•
provides a Paging, Recorded Announcement, Emergency Recorder,
and Music interface.
Each NT5K19 trunk circuit is capable of providing the following:
•
2-wire and 4-wire E&M Type 1 trunk (DC5-A) operation
•
2280 Hz Tie trunk (AC15-A) operation
•
Paging access
•
Recorded Announcement access