Configuring What You Want The Business Secure Router To Log; Displaying Logs; Table 91 Log Categories And Available Settings - Nortel 252 Configuration

Configuring what you want the Business Secure Router to
log
Use the sys logs load command to load the log setting buffer that is used to
configure which logs the Business Secure Router is to record.
Use sys logs category followed by a log category and a parameter to decide what
to record.

Table 91 Log categories and available settings

Log Categories
access
attack
error
ike
ipsec
javablocked
mten
upnp
urlblocked
urlforward
Use the sys logs save command to store the settings in the Business Secure Router
(you must do this in order to record logs).

Displaying logs

Use the sys logs display command to show all of the logs in the Business Secure
Router's log.
Use the sys logs category display command to show the log settings for all of the
log categories.
Available Parameters
0, 1, 2, 3
0, 1, 2, 3
0, 1, 2, 3
0, 1, 2, 3
0, 1, 2, 3
0, 1, 2, 3
0, 1
0, 1
0, 1, 2, 3
0, 1
Use 0 to not record logs for that category, 1 to record only logs for
that category, 2 to record only alerts for that category, and 3 to
record both logs and alerts for that category.
Nortel Business Secure Router 252 Configuration — Advanced
Appendix J Log descriptions 329