Table of Contents
Advertisement
Configuring the Network Adapters and Protocols
Go to
1.
Select the
2.
(i.e., cards) currently configured (e.g., the first span is represented by
TXn000 LAN adapter <CP.1>
TXn000 LAN adapter <CP.2>
Click on
3.
You will then see the Select Network Adapter screen.
Click on
4.
Make sure the
5.
then click on
The Select NMS Communications Processor dialog box opens. This dialog
box only shows the board address for the TX-2000 board previously installed.
Figure 3-2.
Select the board to use and then click on
6.
The Select NMS Products to Install/Configure dialog box opens.
Select
7.
The TXn000 [CP.n] NCPI LAN Driver Configuration dialog box opens. There
are no changes needed in this dialog box.
303321-A Rev. 00
Network Control Panel
tab. You should then see a list of
Adapters
to add the new card you want to configure.
Add
and type
Have Disk
NMS TXn000 Communications Processor
.
OK
Select NMS Communications Processor Screen with
Previous Board
TCP/IP Local Area Network Interface
.
, the second span is represented by NMS
, etc.).
.
c:\txnicdrv
.
Select
and then click on
Configuring the Software
Network Adapters
NMS
is highlighted and
.
OK
3-3
Advertisement
Table of Contents
