Cabling a fiber-optic module
To cable a fiber-optic module, do the following:
1. Remove the protective covering from the fiber-optic port connectors and store
2. Gently insert the two cable connectors (a tab on each connector should face
Cleaning fiber-optic modules
To avoid problems with the connection between the fiber-optic module port and the
fiber cable connector, IBM strongly recommends cleaning both connectors before
making this connection. In particular, dust can accumulate in either connector and
cause problems such as reducing the optic launch power.
When not using a fiber-optic module port connector, make sure to keep the
protective covering on.
28
IBM Ethernet Switch c-series Installation and User Guide
the covering for future use.
upward) into the port connectors until the tabs lock into place.