Sony DSC-HX300 Service Manual page 19

(20) Connect the 5th Assy Flexible Board to the connector on the Main Flexible Board.
5th Assy
Flexible Board
Main Flexible Board
(21) Stick the Shutter Flexible Board.
Shutter Flexible Board
Main Flexible Board
Adhesive Tape
(22) Solder the Main Flexible Board and the Shutter Flexible Board.
(23) Stick the Polyester Tape.
Solders
Polyester Tape
DSC-HX300_L2
Shutter Flexible Board
Main Flexible Board
1-9. FINAL INSPECTION
1-9-1. Confirm There Is No Fault In Actual Motion/Actual Screen
Inspect it as follows when you exchange parts in the lens block.
1 Zoom motion (Check five postures: horizontal, upward/downward, upper/lower oblique 45º)
No abnormal sound or motion must be found over full stroke between TELE end and WIDE end.
2
Zoom image
No abnormality such as a skipped image or wavy image must be found in the image through LCD or finder over full stroke between
TELE end and WIDE end.
4 Appearance condition
Scratches or stains must not be noticeable, except that the customer permits them.
5 Foreign matters on the lens
The lens condition must not be worse than that when the camera was received from the customer.
Note: As for the figure below, this model and the shape
of the main body are different.
Note:
下図は当機種と本体の形状が異なります。
Lens at WIDE end
Full stroke check
Lens at TELE end
1-16
Upward
Horizontal
Downward