Nokia N80 User Manual page 99

entered on the wireless LAN access point device.
Authentication type—Select
authentication type between your device and the wireless
LAN access point device.
WEP key settings—Enter WEP encryption
key), WEP key format (ASCII
key (the WEP key data in the selected format).
Security settings for 802.1x
WPA mode—Select the means of authentication:
use an extensible authentication protocol (EAP) plug-in, or
Pre-shared key to use a password. Complete the
appropriate settings:
EAP plug-in settings (only for EAP)—Enter the settings as
your service provider instructs.
Pre-shared key (only for Pre-shared
password. The same password must be entered on the
wireless LAN access point device.
TKIP encryption (only for WPA/WPA2)—Select whether
Temporal Key Integrity Protocol (TKIP) is used.
Homepage—Define a home page.
Select Options > Advanced settings
following:
IPv4 settings: Phone IP address
device), Subnet mask (the subnet IP address),
Open or Shared for the
(length of the
or Hexadecimal), and WEP
and WPA/WPA2:
EAP to
key)—Enter a
and from the
(the IP address of your
Default
gateway (the gateway), and
addresses of the primary and secondary DNS server.
Contact your Internet service provider for these addresses.
IPv6 settings > DNS address—Select Automatic,
known, or User defined.
Ad-hoc channel (only for Ad-hoc)—To enter a channel
number (1-11) manually, select
Proxy serv. address—Enter the address for the proxy
server.
Proxy port number—Enter the proxy port number.
Packet data
The packet data settings affect all access points using a
packet data connection.
Packet data conn.—If you select
are in a network that supports packet data, the device
registers to the packet data network. Starting an active
packet data connection (for example, to send and receive
e-mail) is quicker. If there is no packet data coverage, the
device periodically tries to establish a packet data
connection. If you select When
packet data connection only if you start an application or
action that needs it.
Access point—The access point name is needed to use
your device as a packet data modem to your computer.
Copyright © 2006 Nokia. All rights reserved.
DNS address—enter the IP
Well-
User defined.
When available and you
needed, the device uses a
99