Advertisement
Taking care of your machine
Cleaning and replacing the filter
CAUTION: Ensure that the vacuum is switched off before performing maintenance or troubleshooting checks. For
continuous best performance, the filter should be tapped over a bin every 4-6 uses, to remove dirt and debris, and
replaced every 6-9 months, depending upon use. Do not use your vacuum cleaner without the filter in place.
Press the Dust Bin
Release Button
and turn
the dust bin until the arrow
symbol points to the unlock
symbol. Then pull away the
dust bin.
Cleaning the cyclone separator
Once the dust bin is
removed the cyclone
separator can be lifted
away from the dust bin by
using the handle, as shown.
The dust bin and cyclone
separator can now be
cleaned.
Remove the filter from the
cyclone separator. Tap the
filter over a bin to remove
any dirt/debris or replace
the filter.
To reinstall the dust bin
ensure that the plastic tab
on the cyclone separator
slots into the groove on
the dust bin, as indicated
by the arrow symbol on
side of the dust bin.
Remove the sponge filter
from the filter cover and
wash the sponge filter
under running water, if
required (40 degrees
max). Allow the filter to
dry for 24hrs or until fully
dry before reinstalling.
reinstall the dust bin,
To
ensure that the arrow
symbol
points to the
unlock symbol. Then
turn the dust bin until the
arrow points to the locked
symbol.
Advertisement
