Machine Features; Operation - Festool CONTURO KA 65 Original Instructions Manual

English
Edge bander
Edge thickness
Inner radius
Heating time
Default melting temperatur setting
Melting temperature setting range
Feed speed
Weight as per EPTA procedure 01:2014:
* Depending on material
5

Machine features

[1-1]
Start button
[1-2] Feed speed button
[1-3]
Handle
[1-4] Rotary knob for adjusting the edge
height
[1-5]
Mains power cable
[1-6] Extractor connector
[1-7]
Switch for temperature selection
[1-8] On/Off switch
[1-9] Safety lever for purging
[1-10] Inlet roller
[1-11] Edge inlet
[1-12] Central plate
[1-13] Drip catcher
[1-14] Adhesive nozzle
[1-15] Contact roller
[1-16] Handle
[1-17] Support base with start marking
[1-18] Flap
[1-19] Menu buttons
[1-20] Display
[1-21] Refill button
The specified illustrations appear at the begin­
ning of the Operating Instructions.
20
Setting 1
Setting 2
Setting 1/2
1st gear
2st gear
6

Operation

WARNING
Unauthorised voltage or frequency!
Risk of accident
► The mains voltage and the frequency of the
power source must correspond with the
specifications on the machine's name
plate.
► In North America, only Festool machines
with the voltage specifications 120 V/60 Hz
may be used.
6.1 Initial operation
► Remove protective foil from underneath the
support base [1-17] and display [1-20].
The machine may generate large quanti­
ties of smoke and a pungent odour when
operated for the first time.
Do not use the machine and working ma­
terials below 15 °C. Recommendation:
room temperature.
6.2 Preparing for operation
► Install the support base (see figure [2]).
► Insert the plug into an earthed socket.
► Insert a minimum of two adhesive cartridg­
es in the magazine. (see chapter 8.2).
► Set the heating temperature for the rele­
vant adhesive cartridges.
Melting temperature selection [1-7] according
to the default setting:
Setting 1 = 190 °C
Setting 2 = 200 °C
KA 65
0.5 - 3.0 mm *
> 50 mm *
approx. 8 min
190 °C
200 °C
100 - 210 °C
2 m/min
4 m/min
7.9 kg