Table of Contents
Advertisement
2. Selecting the Installation Site
Indoor Unit
AVOID:
G areas where leakage of flammable gas may be
expected.
G places where large amounts of oil mist exist.
G direct sunlight.
G locations near inverter lamps which may affect
performance of the unit.
G locations near heat sources which may affect
performance of the unit.
G locations where external air may enter the room
directly. This may cause "sweating" on the air
discharge ports, causing them to spray or drip.
G locations where the remote control unit will be
splashed with water or affected by dampness or
humidity.
G installing the remote control unit behind curtains or
furniture.
G locations where the receiver in the indoor unit is
exposed to the inverter lamp light. Faulty operation
of the unit occurs.
DO:
G select an appropriate position from which every
corner of the room can be uniformly cooled.
G select a location where the ceiling is strong enough
to support the weight of the unit.
G select a location where tubing and drain pipe have
the shortest run to the outdoor unit.
G allow room for operation and maintenance as well
as unrestricted air flow around the unit.
G install the unit within the maximum elevation
difference above or below the outdoor unit and
within a total tubing length from the outdoor unit as
detailed in Table 1-6.
G allow room for mounting the remote control unit
about 3 ft. off the floor, in an area that is not in
direct sunlight nor in the flow of cool air from the
indoor unit.
NOTE
G Air delivery will be degraded if the distance from the
floor to the ceiling is greater than 10 ft..
Ceiling-Mounted Type
Min.10 inch
NOTE
The rear of the indoor unit can be installed flush
against the wall.
Air
discharge
Min.2 ft.
Recessed Type
3 ft.
3 ft.
Wall-Mounted Type
Min.
6 inch
7
S4179705
Ceiling
Wall
Min.10 inch
Front view
Ceiling
Air intake
Side view
1091_T_I
3 ft.
3 ft.
3 ft.
1330_X_S
Min.
6 inch
Min.
12 inch
0930_K_I
Advertisement
Table of Contents
