Flame Baffles; Media Arrangement - Dimplex OLF46-AM Installation And User Manual

Installation

Flame Baffles

The unit comes with the slotted baffles pre-installed
to create a uniform flame. If desired, customize the
appearance of the flame using the provided individual
baffles.
1. To remove the pre-installed baffles, insert a screwdriver
into a slot of the baffle and carefully remove each one.
2. Separate the single baffles provided by bending the
strip until each baffle breaks off.
3. To insert the baffles, use a screwdriver to carefully pry
open the flame output slot on the top cover. Install the
baffle by putting the side with the two tabs down, and
inserting it so that the lip on the top cover goes over
the baffle.
!
NOTE: If installed correctly, the baffle should not be
able to slide within the flame output slot.
4. Place the baffles across the flame output slot as
desired to create the desired flame appearance.

Media Arrangement

1. Install media bed with the angled side of the slot
toward the back of the fireplace. (Figure 15)
2. Evenly disperse the small crystals to entirely cover the
media bed.
3. Place the driftwood pieces across the crystals.
4. Place the large and extra-large crystals as desired
over the smaller crystals and beside the driftwood.
!
NOTE: It is not recommended to position the
driftwood pieces across the flame output slot. If this
configuration is desired, use the provided single
baffles to block the mist beneath the log(s) to prevent
condensation.
It is possible to use custom media ornaments to decorate
your fireplace. The custom media must fit easily without
scratching the glass or bowing the media bed, and must
not be composed of sand or liquid, which could interfere
with the safety of the fireplace.
Figure 14
Figure 15
17