Installing the heat sink (UMA)
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE:
This procedure applies only to computers shipped with an UMA graphics processor.
The following image(s) indicate the location of the heat sink (UMA) and provides a visual representation of the installation
procedure.
Steps
1. Place the heat sink on the system board.
2. Align the screw holes on the heat sink with the screw holes on the system board.
3. In sequential order (1 > 2 > 3 > 4) tighten the four captive screws that secure the heat sink to the system board.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
Removing the heat sink (discrete)
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
About this task
The following image(s) indicate the location of the heat sink (discrete) and provides a visual representation of the removal
procedure.
After working inside your
Before working inside your
computer.
computer.
Removing and installing components
39