Display Wall Mount Instructions - Health O Meter 498KL User Instructions

DISPLAY WALL MOUNT INSTRUCTIONS

Caution: When wall mounting the display assembly, ensure that the mounting location is
free of electrical lines, gas pipes, and other safety hazards. Ensure that wall is of
construction that can support the display assembly.
Note: Remote head can be mounted to a wall up to 6 feet (1.83 m) from the base or it can be
mounted on the display bracket (included) for placement on a table up to 6 feet (1.83 m) from
the base.
Note: For wall mounting, mount display assembly directly to the wall. Do not use display bracket
for wall mount. Display bracket is for surface use only.
Required Parts
(1) Display assembly
(2) #8 Anchoring screws (4.2 mm nominal OD) (NOT INCLUDED)
(2) Mounting anchors, compatible with wall construction (NOT INCLUDED)
1. Position the display assembly on the wall, and carefully trace around the display outline.
2. Mark a level horizontal line, 2.75" (70 mm) below the top of the display outline.
3. Mark a vertical line 3.1" (80 mm) from each side of the display outline.
4. Use the appropriate plastic or metal anchors for the type of wall construction.
5. At the horizontal and vertical intersections, carefully drill the appropriate sized holes.
6. Insert the anchors into the wall, and screw the two mounting screws into the anchors.
Adjust the screw head depth such that the screw heads protrude 0.125" (3.2 mm) from the
wall. Warning: Extending the screw heads beyond 0.125" (3.2 mm) can damage the
display assembly.
7. Position the display assembly mounting holes onto the mounting screws and pull down on
the display assembly to secure the bracket over the screws.
Mounting hole
3.1" (80 mm)
P/N UM498KL Rev20210930_S
2.75" (70 mm)
Mounting hole
8
Display assembly
3.1" (80 mm)