Problem Solving - Theben LUXORliving System Manual

10.2 Problem solving

10.2.1 What is the reason that LUXORplug cannot establish a connection to
the IP1 system centre?
After applying the bus voltage, the system centre needs approx. 1 minute for start-up, then it
should be ready for operation. If access is not possible afterwards, check the following:
If "No LAN" appears on the display of the IP1:
 Check the cable connection to the router.
 Check the router settings (DHCP must be activated).
If "No BUS" appears on the permanent display of the IP1:
 Check the cable connection to the LUXORliving power unit.
10.2.2 What is the default password of the IP1 on delivery?
The password is always "admin".
Why are devices not found when the system is scanned?
10.2.3
Perhaps the device has already been used in another system or KNX system. The device should
be reset to the factory setting. To do this, disconnect the bus voltage, press and hold the Ph.
address button on the device.
While the button is held, switch the bus back on. After approx. 2 seconds, the button can be
released. The LED will go out and the device is reset to factory settings.
How are LUXORliving devices reset to factory settings?
10.2.4
The LUXORliving devices are reset to factory settings as follows:
 Disconnect the device from the KNX bus voltage.
 Press and hold the programming button.
 Reconnect the device to the KNX bus voltage while pressing the programming button.
 Release the programming button after approx. 1 second.
 The programming LED will go out and the device is reset to factory settings.
Exception – LUXORliving BI180 WH:
 Disconnect the device from the KNX bus voltage.
 Turn the potentiometer "Prog. Mode" clockwise to the position "On".
 Press and hold the integrated push button.
 Reconnect the device to the KNX bus voltage while pressing the push button.
 Release the push button after approx. 1 second.
LUXORliving system manual
FAQs concerning the LUXORliving webpage
101