Table of Contents
Advertisement
data and is represented as a complement of 2. The
setting values are in the range between –100 and +100.
The values are specified as follows:
7
6
5
1
2
1 Mark data
+ = 0
– = 1
2 Numerical value data
Select 3D Offset (4AH)
This command is used to set the 3D offset mode.
The values are specified as follows.
1 3D offset
AUTO = 01
ON = 10
OFF = 11
Status Sense (60H)
This command is used to sense the status of the
monitor's current operation. The remote controller can
specify which items of data should be replied. Specify
them in one data byte.
The values are specified as follows:
7
6
5
1
The bit to request the reply must be set to 1.
1 Selected offset
2 Current Input Configuration
If there is no reply, a NAK is issued.
The monitor will send Status Reply (70H) to the remote
controller.
18
Command Description
4
3
2
1
0
4
3
2
1
0
2
White Balance Sense (61H)
This command is used to obtain the values for USER of
the white balance data stored in the NVM of the monitor.
The preset white balance data are not changed by this
command.
The values are specified as follows:
7
6
5
4
Bits required for the white balance data
The bit to request the white balance data must be set to 1.
If there is no reply, a NAK is issued.
The monitor will send White Balance Reply (71H) to the
remote controller.
3D Offset Sense (63H)
This command is used to obtain the 3D offset data stored
in the NVM of the monitor.
The values are specified as follows:
7
6
5
4
Bits required for the 3D offset data
The bit to request the 3D offset data must be set to 1. If
there is no reply, a NAK is issued.
The monitor will send 3D Offset Reply (73H) to the
remote controller.
User Memory Sense (65H)
This command is used to obtain the values for user
memory data stored in the NVM of the monitor.
The user memory data is not loaded by this command.
The values are specified as follows:
7
6
5
4
1
2
1 User memory control
Data send for user memory = 11
2 User memory number
Specifies the numbers 01 to 20.
If there is no reply, a NAK is issued.
The monitor will send User Memory Reply (75H) to
the remote controller.
3
2
1
0
3
2
1
0
3
2
1
0
Advertisement
Table of Contents
