Electrical Adjustments; Test Mode; Md Section; Tuner Section - Sony MDX-C8900 Service Manual

Fm/am mini disc player
Hide thumbs Also See for MDX-C8900:
Table of Contents

Advertisement

TEST MODE

This set have the test mode function. In the test mode, FM Auto
Scan/Stop Level and AM Auto Scan/Stop Level adjustments can
be performed easier than it in ordinary procedure.
<Set the Test Mode>
1. Set the "power select" switch (SW500) is "A (ON)" position.
2. Turn ON the regulated power supply. (All LEDs on the set
lights up, and the clock is displayed.)
[OFF]
Note: Press the
button, if the clock is not displayed.
[4]
3. Push the preset
button.
[5]
4. Push the preset
button.
[1]
5. Press the preset
button for more than two seconds.
6. Then the display indicates all lights, the test mode is set.
<Release the Test mode>
[OFF]
1. Push the
button.
2. Return the "power select" switch (SW500) to initially set po-
sition.
See the adjustment location from on page 25 for the ad-
justment.

MD SECTION

MD section adjustments are done automatically in this set.
SECTION 3

ELECTRICAL ADJUSTMENTS

Note: Adjust the tuner section in the sequence shown below.
1. FM Auto Scan/Stop Level Adjustment
2. FM Stereo Separation Adjustment (Wide)
3. FM Stereo Separation Adjustment (Narrow)
4. AM Auto Scan/Stop Level Adjustment
FM Auto Scan/Stop Level Adjustment
Setting:
Procedure:
1. Set to the test mode.
2. Push the
3. Adjust the volume RV2 on TU1 by turning clockwise untill
Adjustment Location: See page 25.
– 23 –

TUNER SECTION

Cautions during repair
When the tuner unit is defective, replace it by a new one be-
cause its internal block is difficult to repair.
Band: FM
FREQUENCY SELECT switch (E model): FM 200 k
FM RF signal
generator
Carrier frequency
: 97.9 MHz
: 22 dB (12.6 µ V)
Output level
Mode
: mono
Modulation
: 1 kHz, 22.5 kHz deviation (30%)
[SOURCE]
button and set to FM.
Display
"0" is shown next to "FM" on the display window, If "0" is
already shown or the volume RV2 has been turned too far,
turn it back counterclockwise untill "0" is disappeared once,
then try this adjustment.
Display
0 dB=1µV
antenna jack (CNP1)
0.01 µ F
set
SHUF
SHUF

Advertisement

Table of Contents
loading

Table of Contents