Setup Submenu; Inserting A Minisd Card - Nextar SNAP3 Hardware Instruction Manual

Global Positioning System

Setup Submenu

On this setting page, you can customize the
device settings, such as backlight, volume,
date and time. Once you change the
settings, your new settings will remain until
you change them again.
Button Name
Clock
Volume
Battery
Display
Bluetooth
System

Inserting a MiniSD Card

The GPS device is designed with a miniSD Card slot which allows you to insert the miniSD card into the
GPS device.
To use the miniSD card, insert it into the slot of the
device, with the connector pointing to the slot and
its label facing the front of the device.
To remove the card, first make sure that no
application is accessing the card, and then slightly
push the top edge of the card to release and pull it
out of the slot.
Note
12
Allowing you to select a Time Zone and set the current date
and time
Allowing you to enable or disable the key tone of touch pad
and adjustment the volume of system
Allowing you to read the battery status and set the system's
idle time
Allowing you to set the LCD's idle time and adjust the
backlight of LCD
Allowing you to search for a Bluetoooth device around and
pair the Bluetoooth device with your product
Showing the information on the system's brief specification
1. Make sure that no foreign object enters the miniSD card slot.
2. Keep a miniSD card in a well protective box to avoid dust and
humidity when you are not using it.
Description