Installing The Injection System To A Hydroject 3000 - Toro 09830 Operator's Manual

Installing the Injection System
to a HydroJect 3000
IMPORTANT: The HydroJect 3000 Aerator
MUST be equipped with a regulator and
pre-filter. If not, you must purchase and
install these kits before you install the
Injection System. (Contact your Authorized
TORO Distributor.)
1. Remove the fuel tank from the HydroJect 3000
Aerator (Fig. 1).
1
Figure 1
1. Fuel Tank
2. 90-degree Black Plastic
Elbow Fitting
2
3
3. Brass Adapter Fitting
2. Remove the hose between the water filter and
the water pump (Fig. 2).
2
Figure 2
1. Hose (between water filter
and pump)
3. Remove the black pressure gauge hose from the
90-degree black plastic elbow fitting (Figs. 1
and 2).
4. Remove the 90-degree black plastic elbow fitting
from the brass adapter fitting and discard
(Fig. 1).
5. Remove the brass adapter fitting from the outlet
side of the filter and discard (Fig. 1).
Installation
1
2. Black Pressure Gauge
Hose
7