Optional Accessories - DeWalt DWV015 Instruction Manual

English
visual damage to the filter membrane exists, replace
filters. Filters typically last between six and twelve
months, depending on use and care.
To Install Filters (Fig. J)
1. Ensure filter seal 22 is in place and is secure
2. Line up filter threads
using moderate force, turn filter clockwise until tight.
nOTE: Use care to not damage filter material.
3. Place the vacuum head
it by closing the canister latches
Cleaning

WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this procedure.

WARNING: Never use solvents or other harsh
chemicals for cleaning the non‑metallic parts of the
tool. These chemicals may weaken the plastic materials
used in these parts. Use a cloth dampened only with
water and mild soap. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
Storage (Fig. K)
1. Empty the canister, refer to To Empty Canister
under Operation.
2. Clean the vacuum inside and outside.
3. Clean or replace filters, refer to Filters.
4. Remove the hose 7 from the twist‑lock hose inlet
and close the inlet with the inlet plug
5. Put the ends of the suction hose together to prevent dirt
particles from escaping.
6. Store the suction hose and the power cord as shown in
the illustration. Place the unit in a dry room and secure it
from unauthorized use.
nOTE: Plug inlet plug into inlet to keep debris inside
canister when suction hose is removed. You can also
attach the ends of the hose together and lock together
with the twist‑lock end.
nOTE: After wet applications, the internal parts of the
liquid container must be dried before storage.
Accessories

WARNING: Since accessories, other than those offered
by D WALT, have not been tested with this product, use
e
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center. If you need assistance in locating any
accessory, please contact D
Joppa Road, Towson, MD 21286, call 1‑800‑4‑D
433‑9258) or visit our website: www.dewalt.com.
8
23 to vacuum head threads and
3 onto the container and secure
4 .
19
WALT recommended
e
WALT Industrial Tool Co., 701 East
e
WALT (1‑800‑
e

Optional Accessories

10
The filter bags provide a clean, easy and quick way to
dispose of the dust collected.
If you remove the the rack DWV016TSRK from the Vac use
the screws supplied with the rack to close the screw holes
on top of the Vac Head
HEPA filter: Captures
99.97% of all particles
DWV9320 (some models)
greater than or equal to
0.3 microns. Required
DWV9330 (some models)
when picking up lead
paint debris.
5"–6" (127–152 mm)
DWE46100 Cutting/tuckpointing
shroud
D25301D Dust extraction adapter
5" (127 mm) Surfacing
DWE46152
shroud
DWH050 Universal drilling
DWH050K
dust extraction system
1-1/8" Hex hammer dust
DWH052K
collection
DWH053 SDS Max and
DWH053K spline chipping dust
collection
DWV9316 Anti-static 14' (4.3 m) hose
Crush proof 14' (4.3 m)
DWV9315
hose
DWV9336 36 mm anti-static hose
DWV016TSRK Storage Rack Accessory