Creating An Initial Ram Disk; Rebooting The Os - Fujitsu ETERNUS DX Configuration Manual

Chapter 2 Setup Procedure for QLogic Converged Network Adapter Cards
2.5

Creating an Initial RAM Disk

(After)
alias eth0 tg3
alias eth1 tg3
alias scsi_hostadapter megaraid_mbox
alias scsi_hostadapter1 ata_piix
# install qla2xxx /sbin/modprobe qla2xxx_conf; /sbin/modprobe --ignore-install qla2xxx
# remove qla2xxx /sbin/modprobe -r --first-time --ignore-remove qla2xxx && { /sbin/modprobe -r --ignore
-remove qla2xxx_conf; }
alias qla2100 qla2xxx
alias qla2200 qla2xxx
alias qla2300 qla2xxx
alias qla2322 qla2xxx
alias qla2400 qla2xxx
# options qla2xxx for MPD (Do not edit this line)
options qla2xxx ql2xfailover=0 ConfigRequired=0 ql2xmaxqdepth=8
alias scsi_hostadapter2 qla2xxx_conf
alias scsi_hostadapter3 qla2xxx
alias scsi_hostadapter4 mpdh
2.5 Creating an Initial RAM Disk
Create an initial RAM disk image file to match the kernel being used. Refer to the QLogic Converged Network
Adapter card manual for details on the creation method.
2.6

Rebooting the OS

Reboot the OS. After restarting the OS, use the "modinfo qla2xxx" command to confirm that the correct ver-
sion of the Converged Network Adapter card driver is installed.
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (FCoE) for Linux
Copyright 2018 FUJITSU LIMITED
ql2xtgtemul=1
18
P3AM-6402-11ENZ0