Restoring The Default Configuration And Password - NETGEAR RangeMax Next WNR834B Reference Manual

— Check that your cable or DSL modem is connected and functioning.
— If your ISP assigned a host name to your computer, enter that host name as the Account
Name in the Basic Settings menu.
— Your ISP could be rejecting the Ethernet MAC addresses of all but one of your computers.
Many broadband ISPs restrict access by only allowing traffic from the MAC address of
your broadband modem, but some ISPs additionally restrict access to the MAC address of
a single computer connected to that modem. If this is the case, you must configure your
router to "clone" or "spoof" the MAC address from the authorized computer. For more
information, see

Restoring the Default Configuration and Password

This section explains how to restore the factory default configuration settings, changing the
router's administration password to password and the IP address to 192.168.1.1. You can erase the
current configuration and restore factory defaults in two ways:
• Use the Erase function of the router (see
• Use the Default Reset button on the rear panel of the router. Use this method for cases when
the administration password or IP address is not known.
To restore the factory default configuration settings without knowing the administration password
or IP address, you must use the Default Reset button on the rear panel of the router.
1. Press and hold the Default Reset button until the test light blinks on (about 10 seconds).
2. Release the Default Reset button and wait for the router to reboot.
If the wireless router fails to restart or the power light continues to blink or turns solid amber,
the unit may be defective. If the error persists, you might have a hardware problem and should
contact technical support.
Troubleshooting
RangeMax Next Wireless Router WNR834B Reference Manual
"How to Manually Configure Your Internet Connection" on page
"Erasing the Configuration" on page
v1.0, April 2006
3-6.
6-6).
8-7