Setting The Mtu Size; Using The Lan Ip Setup Options - NETGEAR KWGR614 Reference Manual

54Mbps Wireless Router Model KWGR614 Reference Manual

Setting the MTU Size

The default MTU size is usually fine. The normal MTU (Maximum Transmit Unit) value for most
Ethernet networks is 1500 Bytes. For some ISPs, particularly some using PPPoE, you may need to
reduce the MTU to 1492. This should not be done unless you are sure it is necessary by your ISP.
Any packets sent through the router that are larger than the configured MTU size will be
repackaged into smaller packets to meet the MTU requirement. To change the MTU size:
1. Under MTU Size, enter a new size between 64 and 1500.
2. Click Apply to save the new configuration.

Using the LAN IP Setup Options

The second feature category under the Advanced heading is LAN IP Setup. This menu allows
configuration of local TCP/IP addresses, DHCP and address reservation. From the Main Menu of
the browser interface, under Advanced, click on LAN IP Setup to view the LAN IP Setup menu,
shown below.
Figure 5-6
Advanced Configuration of the Router 5-9
v1.2, September 2006