Indoor Installation Guideline - Daikin R32 SPLIT Series Installation Manual

INDOOR INSTALLATION GUIDELINE

INSTALLING THE MOUNTING PLATE
• The mounting plate should be installed on
a wall which can support the weight of the
indoor unit.
1) Temporarily secure the mounting plate to the
wall, make sure that the panel is completely
level, and mark the drilling points on the wall.
2) Secure the mounting plate to the wall with
screws.
INDOOR UNIT FTXC20/25/35/50
INDOOR UNIT FTXC60/71
 Recommended mounting plate
retention spots (7 spots in all)
DRILLING A WALL HOLE AND INSTALLING WALL EMBEDDED PIPE
• For walls containing metal frame or metal board, be sure to use a wall embedded pipe and wall cover in the feed-through
hole to prevent possible heat, electrical shock, or fire.
• Be sure to caulk the gaps around the pipes with caulking material to
prevent water leakage.
1) Drill a feed-through hole of 65mm in the wall so it has a down slope
toward the outside.
2) Insert a wall pipe into the hole.
3) Insert a wall cover into wall pipe.
4) After completing refrigerant piping, wiring, and drain piping, caulk
pipe hole gap with putty.
 Recommended mounting plate
Place a leveler on these tabs.
retention spots (7 spots in all)
117
Ø 65
49.5 170
Place a leveler on these tabs.
117
Ø 65
49.5 170
Recommended mounting plate retention spots and dimensions
Mounting plate
Mounting plate fixing screw
Use a tape measure as shown.
Position the end of the tape
measure at 
116.5
Ø 65
50 170 49.5
770
Use a tape measure as shown.
Position the end of the tape
measure at 
126.5
Ø 65
170
60
990
Wall embedded pipe
(Field supply)
The mounting plate should
be installed on a wall
which can support the
weight of the indoor unit.
Through-the-wall
hole Ø 65mm
Drain hose position
unit : mm
All dimensions are in mm
Through-the-wall
65.5
hole Ø 65mm
Drain hose position
unit : mm
All dimensions are in mm
Inside Outside
Caulking (Putty)
(Field supply)
Wall hole cover
(Field supply)
Wall embedded pipe
(Field supply)
ENGLISH
Ø 65
5