Product Illustration; Front Panel - NETGEAR ProSafe GS504 Installation Manual

Product Illustration

Front Panel

The front panel of the Model GS504 switch contains the following LEDs that
correspond to each network port: Activity (Rx/Tx) and FDX (full-duplex)/
Collision. Each fiber network port has its own Link LED (located to the right of
each 1000 Mbps port).
4
PORT
10/100Mbps Gigabit Fiber Switch
Power
Power LED
LEDs
The table below describes the activity of the LEDs.
Label Color
Power Green
FDX/Col Green
Yellow
Activity Green
Link Green
Model GS504 4-Port Gigabit Switch Installation Guide
Front Panel of the Model GS504 Switch
Activity
LEDs
1 2
Tx Rx Tx Rx
Link
Activity
1 2 3 4
Green=FDX, Yellow=Col
FDX/Collision LED
Activity Description
On Power is supplied to the switch.
Off Power is disconnected.
On The port is operating in full-duplex mode.
Off The port is operating in half-duplex mode.
Blinking Data collisions are occurring on the port. In a full-
duplex environment, there is no collision. In a half-
duplex environment, some collisions are normal.
Blinking Packet transmission or reception is occurring on
the port.
On A valid 1000 Mbps link is established on the port.
Off A link is not established on the port.
Fiber network
ports
Ethernet
MODEL GS504SX
3 4
Tx Rx Tx Rx
Link Link Link
Link
LED
9318FA