Table of Contents
Advertisement
Validate
To validate the hostname in the SSL certificate
Hostname
in
Certificate
Enable SIP
Notify
Device will challenge NOTIFY with 401 when set to Yes
Authentic
ation
Factory
Press Start to begin Factory Reset of the phone.
reset
Syslog
If set to SSL/TLS, the syslog messages will be sent through secured TLS protocol to syslog server.
Syslog
Default setting is "UDP".
Protocol
Note: The CA certificate is required to connect with the TLS server.
The URL or IP address of the syslog server for the phone to send syslog to.
Syslog
Note: By adding port number to the Syslog server field (i.e., 172.18.1.1:1000), the phone will send syslog to the
Server
corresponding port of that IP.
Selects the level of logging for syslog.
The default setting is "None". There are 4 levels: DEBUG, INFO, WARNING and ERROR.
Syslog messages are sent based on the following events:
● Product model/version on boot up (INFO level).
● NAT related info (INFO level).
● sent or received SIP message (DEBUG level).
Syslog
● SIP message summary (INFO level).
Level
● inbound and outbound calls (INFO level).
● registration status change (INFO level).
● negotiated codec (INFO level).
● Ethernet link up (INFO level).
● SLIC chip exception (WARNING and ERROR levels).
● Memory exception (ERROR level).
Syslog
Syslog will be filtered based on keywords provided. If you enter multiple keywords, it should be separated by ','.
Keyword
Please note that no spaces are allowed.
Filter
Configures whether the SIP log will be included in the syslog messages. The default setting is "No".
Send SIP
Note: By setting Send SIP Log to Yes, the phone will still send SIP log from syslog even when Syslog Level set
Log
to NONE.
Packet Capture
With RTP
Defines whether the packet capture file contains RTP or not. The default setting is "No".
Packets
With
Configures whether the packet capture file contains secret key information or not.
Secret Key
Informatio
Enabled by Default
n
Ping
Maintenance �� System Diagnosis
Advertisement
Table of Contents
